Dear Colleagues I am quite new for Matlab/Dynare. and I really need your support to improve the Dynare code. In my current work, I develop the DSGE model and try to run it in Dynare but there is some problems as belows: ERROR: Can’t open file Model_cali_noF_Simul/checksum Error using dynare (lin…

Hi khuncha1402, There were some open-end loops and other minor code re-adaptations you had not taken care of, but now the code runs through. I will not dwell on your results here, but notice for your information that although you have set up a figure for “The costs of price dispersion”, the corres…

Also, regarding the original message, please see [image] Checksum file Installation and Setup Hi! I’m simulating a deterministic new-keynesian model. Dynare return this kind of error: " can’t open file filename/checksum" I don’t know what the checksum file is, and so i…

Thank you so much for supports. I replaced by this file and try to run this again but the same problem came out. Please let me know which version of dynare that you used. Thank you so much

Dynare 4.5.6. Using that version, the code attached to my reply runs through. Also, the comments in that reply still apply. :slightly_smiling_face:

ERROR: Can't open file Model_cali_noF_Simul/checksum

jpfeifer 21 February 2020 20:49 3

Also, regarding the original message, please see