ERROR: Can't open file Model_cali_noF_Simul/checksum

1

Dear Colleagues

I am quite new for Matlab/Dynare. and I really need your support to improve the Dynare code.

In my current work, I develop the DSGE model and try to run it in Dynare but there is some problems as belows:

ERROR: Can’t open file Model_cali_noF_Simul/checksum
Error using dynare (line 265)
DYNARE: preprocessing failed

Since this code run before I make more simulation exercises. I do not understand where the error comes from?

I attached my Dynare code. Someone please help me solve this problem.
I greatly appreciate any support.

Thank so much.

Your sincerely.Model_cali_noF_Simul.mod (23.6 KB)

2

Hi khuncha1402,

There were some open-end loops and other minor code re-adaptations you had not taken care of, but now the code runs through.
I will not dwell on your results here, but notice for your information that although you have set up a figure for “The costs of price dispersion”, the corresponding plotting functions and objects to be plotted are still missing, so that no plot appears on the figure.
You might want to add that.
Model_cali_noF_Simul.mod (23.7 KB)

3

Also, regarding the original message, please see

4

Thank you so much for supports.

I replaced by this file and try to run this again but the same problem came out. Please let me know which version of dynare that you used.
Thank you so much

5

Thank you so much for supports.

I replaced by this file and try to run this again but the same problem came out. Please let me know which version of dynare that you used.
Thank you so much

6

Dynare 4.5.6.

Using that version, the code attached to my reply runs through.
Also, the comments in that reply still apply. :slightly_smiling_face: